Warning: Cannot modify header information - headers already sent by (output started at /home/epn/detail.php:169) in /home/epn/detail.php on line 258
Tiny Spectrum Analyzer TinySA 2.8inch LCD Display 100khz-960mhz +Battery 16 bits for Sale - BlackBerryForums.com

Tiny Spectrum Analyzer TinySA 2.8inch LCD Display 100khz-960mhz +Battery 16 bits For Sale

Tiny Spectrum Analyzer TinySA 2.8inch LCD Display 100khz-960mhz +Battery 16 bits


Buy Now

Tiny Spectrum Analyzer TinySA 2.8inch LCD Display 100khz-960mhz +Battery 16 bits:
$61.87

Tiny Spectrum Analyzer TinySA 2.8inch LCD Display 100khz-960mhz +Battery 16 bits


Description:

-Condition: 100% brand new and high quality

-Item Name:TinySA 2.8" Spectrum analyzer

-Color: Black

*Display resolution 320*240 pixels

* Screen diagonal 2.8"

* 16 bits per RGB pixels

*Frequency accuracy: <2ppm

*Frequency stability: <1ppm

*USB interface: USB type-C

*Communication mode: CDC (serial)

*Power supply: USB 5V 150mA

*Built-in: 650mAh battery, maximum charging current 300mA,

*Charging time: 1 hour 2 hours

* Resistive touch control

* Jog switch control

* USB serial port control

* Optional TTL USART port (SW not yet implemented) on the internal PCB

* Linear power supply to avoid switching noise

*Reference generator spec:

- Optional square wave output with fundamental at -25dBm connected to high input/output.

-Frequency can be set to 1MHz, 2MHz, 4MHz, 10MHz, 15MHz or 30MHz.

*Battery spec:

-Charging time max 1 hour on 500mA minimum USB port or USB charger

-Operation on fully charged battery for at least 2 hours


The input/output specification of the tinySA is split over the 4 modes

1. Low input mode spec:

* Input frequency range from 100kHz to 350MHz

* Input impedance 50 ohm when input attenuation set to 10dB or more.

* Selectable manual and automatic input attenuation between 0dB and 31dB in 1 dB steps

* Absolute maximum input level without attenuation of +10dBm

* Absolute maximum input power with 30dB attenuation of +20dBm for short period

* Input Intercept Point of third order modulation products (IIP3) with 0dB attenuation of +15dBm

* 1dB compression point at +2dBm with 0dB attenuation

* Power detector resolution of 0.5dB and linearity versus frequency of +/-1dB

* Absolute power level accuracy after power level calibration of +/- 1dB

* Lowest discernible signal using a resolution bandwidth of 30kHz of -102dBm

* Frequency accuracy equal to the selected resolution bandwidth

* Phase noise of -90dB/Hz at 100kHz offset and -115dB/Hz at 1MHz offset

* Spur free dynamic range when using a 30kHz resolution bandwidth of 70dB

* Manually selectable resolution filters of 3, 10, 30, 100, 300, 600kHz. Automatic selection of one of the 57 resolution filters.

* On screen resolution of 145 or 290 measurement points.

* Scanning speed of over 1000 points/second using largest resolution filters.

* Automatic optimization of actual scanning points to ensure coverage of the whole scan range regardless of the chosen resolution bandwidth

* Spur suppression option for assessing if certain signals are internally generated or actually present in the input signal


2. High input mode spec:

* Input frequency range from 240MHz to 960MHz

* As there is no input bandfilter strong signals outside the 240MHz to 960MHz range can cause distortion of the in band signals

* Absolute maximum input level without attenuation of +10dBm

* Input Intercept Point of third order modulation products (IIP3) of -5dBm

* 1dB compression point at -6dBm with 0dB attenuation

* Power detector resolution of 0.5dB and linearity versus frequency of +/-1dB

* Absolute power level accuracy after power level calibration of +/- 1dB

* Lowest discernible signal using a resolution bandwidth of 30kHz of -115dBm

* Frequency accuracy equal to the selected resolution bandwidth

* Spur free dynamic range when using a 30kHz resolution bandwidth of 50dB

* Selectable (automatic and manual) resolution filters of 3, 10, 30, 100, 300 and 600kHz

* Optional 25dB to 40dB frequency dependent input attenuator. The power level error with this attenuator activated increases to +/- 15dB

* On screen resolution of 145 or 290 measurement points.

* Scanning speed of over 1000 points/second using largest resolution filters.

* Automatic optimization of actual scanning points to ensure coverage of the whole scan range regardless of the chosen resolution bandwidth


3. Low output mode spec:

* Sinus output with harmonics below -40dB of fundamental

* Output frequency range from 100kHz to 350MHz

* Output level selectable in 1dB steps between -76dBm and -6dBm

* Optional AM, narrow FM and wide FM modulation or slow sweep over selectable frequency span


4. High output mode spec:

* Square wave output

* Output frequency range from 240MHz to 960MHz

* Output level selectable in variable increments between -38dBm and +13dBm

* Optional narrow FM and wide FM modulation or slow sweep over selectable frequency span

Package Included:

1 xTinySA 2.8" Spectrum analyzer

2 x20cm sma-sma rg174 rf cabe

1 xUSB Type-C Data Cable

1 xHand rope

1 xSMA female to female connector

1 xSMA telescopic antenna


Note:

Due to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you!




PayPal is the preferred method for payment. If you are paying by bank transfer, please use your exact username as the reference to ensure that your order will get processed smoothly.


* Your order will be shipped within 1 business days ( Excluding Weekends and Public Holidays)after your payment clear.
* We only ship out within US.
* Item will be delivered within 1-6 business days in US.We ship to Paypal confirmed address ONLY. Please make sure your address in PayPal is matched with your shipping address before you pay.
* We do not offer in store pick up and return service.
Besides, Zone 9 is out of our delivery range.


We will keep you updating via email messages regarding the status of orders.Please make sure your registered email available and you adjust the spam limitation to allow messages from us, or check your message box.
Order information will be updated when:After you win the item OR place a new order.After you pay item successfully.After your item dispachted.


We are professional seller.If you need more this item ,please contact us,we can deal the discount price for you .or if you need to find anythings ,we will help you to find it and give you our best price.If you we are not satisfied with the product or service ,please contact me and don\'t give us negative or natural response,We must give you a satisfactory solution.




Buy Now

Related Items:

Tiny Spectrum Analyzer 2.8inch TinySA LCD Display 100khz-960mhz +Battery 16 bits picture

Tiny Spectrum Analyzer 2.8inch TinySA LCD Display 100khz-960mhz +Battery 16 bits

$63.89



Tiny Spectrum Analyzer TinySA 2.8inch LCD Display 100khz-960mhz +Battery 16 bits picture

Tiny Spectrum Analyzer TinySA 2.8inch LCD Display 100khz-960mhz +Battery 16 bits

$63.89



Tiny Spectrum Analyzer TinySA 2.8” LCD 240MHz to 960MHz 100kHz to 350MHz V0.3 picture

Tiny Spectrum Analyzer TinySA 2.8” LCD 240MHz to 960MHz 100kHz to 350MHz V0.3

$62.00



Popular Forums