Looking at my 8310 now (is that what you have?), the card goes in face-up, contacts down in the holder to the right of the SIM (when looking at the back of the phone with the Phone sticker in the battery bay facing you so you can read it). Note that the memory card needs to go into the tabs on either side of the holder, which swings down and locks when you slide it towards you.
can anyone confirm what their conductor pins look like when you open the door?
are all of the spheres on the tips in perfect alignment?
Yes, all pins on the mobo line up with the mem card. Are you sure the mem card is in the slots on either side of the door? Can you close the door without the memory card in it?
Yes, all pins on the mobo line up with the mem card. Are you sure the mem card is in the slots on either side of the door? Can you close the door without the memory card in it?
What mem card do you have?
okay then that might be my problem, the 3rd pin isn't in alignment with the rest.
lol no that wasn't the problem, i'll tell you what the problem is but i need 10 posts before i can post a link. i've gotta post whore it for a second so i can explain where i ran into my issue incase someone else does what i did.
that picture there, where the 3rd pin from the bottom is a little bit off from it being perfectly aligned with the rest of them.....that's what i thought was the problem but it turns out you need to swing the card with the door at the same time in order for it to shut. not sure why but that's how it is and i don't care how it got in anymore, it's in thankfully
OK, there are slots on the side of the door in which the mem card slides into. Then the whole assembly closes as one piece- I think that was your issue.
hey guys new to the forum - micro sd question
)?
In the Media Center section.
