It's brand new, I set up everything with the setup wizard.
Let it charge for a while, then tried to set up the WiFi.
After typing in the password for the connection, it just went blank.
White screen with the hourglass, constantly turning off and on by itself.
When it turns on a "Verifying Security Software" screen pops up it loads 89% and just shuts off & does it all over again. Over and over again with the verifying security software. I took out the battery and left it out for a few minutes & it doesnt change anything. I dont have a memory card, nor have i installed any third party applications.
Try reinstalling the OS. If you can catch it at the right point in the cycle, Desktop Manager will recognize the device and install the OS. It might take a lot of attempts.
If that fails, you'll have to wipe the device using jl_cmdr and then reinstall the OS.
The router may be one of the few that don't interact well with the Curve, but likely there was some problem with the OS. Or perhaps the device itself.
Hi, this happened to me, what i did is go far from where the wi-fi coverage or turn of the wi-fi network of you house, and the magically it will work without turning on and off. So just don´t be around any wi-fi hotspots and then try to set up the network again
i just ordered a new one. since it hasnt been 14 days yet.
i just freaked out. haha.
thanks i'll keep that in mind when i set up the wifi again.
i'll definitely come to you with the wifi help, if you dont mind