ZVS High Voltage Induction Heating Driver Board Module Flyback Driver Heater For Sale

ZVS High Voltage Induction Heating Driver Board Module Flyback Driver Heater


This item has been shown 44 times.

Buy Now

ZVS High Voltage Induction Heating Driver Board Module Flyback Driver Heater:
$8

Store Categories Store Categories

Product View

Description:

ZVS driver module adopts flyback circuit, and it can be used for driving FBT flyback transformer. Because it achieves zero voltage switching, it is generally called ZVS. It has high power, emit a little heat and high reliability, it is widely applied to drive SGTC, Jacob high ladder, Marx generator, induction heating etc

Parameter:

No.

Parameter

Value

1

Operating Voltage

DC 12-30V

2

Power Requirements

When 12V Current >=5A; More 15V,No lower than 10A (the higher of the current is, the higher of the power will be)

3

Operating Frequency

30KHz-50KHz self-adaption

4

Arc Length

1~5cm

5

Output Voltage

IN:12V/5A, Out:10000V 60W;

IN:24V/10A,Out:20000V 200W

6

Max Power

180-360W

7

PCB Size

75*70.6mm

8

Work temperature

-25~85℃

Interface Introduction:

1>.VCC: Voltage positive

2>.GND: Voltage negative

3>.OUT: Output port

4>.COM: Common port

About Flyback Transformer(NOT Include in Listing):

Common transformers of black/white or colorful TV can be used, no matter what the model is. The higher of the power is, the better it will be. Using ZVS to driving the transformer has let it overload operate, so the damage is normal phenomenon. Please note that it cannot operate for a long time with high power

Primary Winding: please use 1.5mm2 wire for 5 circles + 5 circles from the same direction

About Arc Length:

When input voltage 12V/5A, the arc length will be 1-2cm; the higher of the input voltage, current and output power, the longer of the arc length will be; when most input 30V/10A, the longest distance will be more than 5cm. If the arc is too short, please check whether the input power is sufficient

About Power:

Circuit output power depends on your input power, please make sure that the input power is enough. Power=voltage*current

Note:

Driving the flyback transformer is high voltage output, please pay attention to your safety

Application:

1>. SGTC

2>. SJacob ladder

3>. SMarx generator



Buy Now

Popular Forums