This item has been shown 31 times.
100% brand new and high quality
Made of high-quality materials, durable
This meter is a small tool for engineers, electronic repairs and factories.
It is very easy to test plug-in and SMD devices.It can also test different types of diodes, triodes, thyristors, MOSFETs, so as to be able to analyze device types, pin polarity, output HFE, valve voltage, and FET junction 0-50M ohm Resolution: 0.01 ohm
Capacitance: 25pF-100mF Resolution: 1pF
Inductor: 0.01mH-20H Resolution: 0.01mH
Capacitance ESR: 2uF-50mF Resolution: 0.01 ohm
SMD test clamp probe:
Clip opening distance: 10mm
Maximum voltage: 250V
Product length: about 17cm
Cord length: about 43cm
Package size (LxWxH): 17.50 x 10.00 x 6.00 cm / 6.89 x 3.94 x 2.36 testing the capacitor, make sure to discharge it, otherwise the internal circuit may be damaged
If you use a DC power supply, please choose a DC 9V-12V adapter (including 9V and 12V)
It is powered by a 9V 6LR61 battery, when the battery power is lower than 6V, please replace with a new to use instructions:
Press "POWER / TEST" to turn on the power and start the test, you can use this button to repeat multiple measurements, and the power will be turned off automatically 20 seconds after the measurement
Provide three kinds of sockets, each socket's pin 1, pin 2 and pin 3 are all connected
There is a table "Typical ESR Values of Electrolytic Capacitors" on the back for reference only. These are the typical values of standard grade electrolytic capacitors at room the test pins 1, 2, and 3 together, and then press the "POWER / TEST" button, then the screen prompts to enter the calibration, and within 2 seconds press this button again to confirm.
After a few seconds, the screen prompts to release pins 1, 2, and 3, release them and wait for the calibration to list:
1 *Digital Transistor Tester
1 *SMD test clamp probe
1 *English user manual
1. The real color of the item may be slightly different from the pictures shown on website caused by many factors such as brightness of your monitor and light brightness.
2. Please allow slight manual measurement deviation for the data.Payment
We accept payment via Paypal only.
Payment must be completed within 5 days. If you have any problems about payment, please contact us via message.
We only ship to confirmed Paypal addresses. Please comfirm that your paypal address is in line with your shipping address.
Please kindly note that the combined shipping is not provided because the shipping fee is calculated by weight. Also, the each additional item means exactly the the same color and size.
It takes about 7-15 working days to US; about 10-30 working days to other countries. Transit time may be a little delayed because of the bad weather and customs inspection. If you do not receive your item within 30 working days since payment finished, please contact us immediately for further us
We strive for 100% customer satisfaction! Positive response is very important to us. If you have any questions, please feel free to contact us via "Ask seller a question" . We will reply your email within 24 working hours.
On 23-Sep-20 at 12:16:08 EDT, seller added the following information: