GY-4466 Microphone amplifier module max4466 adjustable gain for arduino ^EYWIXGE For Sale

GY-4466 Microphone amplifier module max4466 adjustable gain for arduino ^EYWIXGE


This item has been shown 64 times.

Buy Now

GY-4466 Microphone amplifier module max4466 adjustable gain for arduino ^EYWIXGE:
$4

This fully assembled and tested board comes with a 20-20KHz electret microphone soldered on. For the amplification, we use the Maxim MAX4466, an op-amp specifically designed for this delicate task! The amplifier has excellent power supply noise rejection, so this amplifier sounds really good and isn't nearly as noisy or scratchy as other mic amp breakouts we've tried!
This breakout is best used for projects such as voice changers, audio recording/sampling, and audio-reactive projects that use FFT. On the back, we include a small trimmer pot to adjust the gain. You can set the gain from 25x to 125x. That's down to be about 200mVpp (for normal speaking volume about 6" away) which is good for attaching to something that expects 'line level' input without clipping, or up to about 1Vpp, ideal for reading from a microcontroller ADC. The output is rail-to-rail so if the sounds gets loud, the output can go up to 5Vpp!
Using it is simple: connect GND to ground, VCC to 2.4-5VDC. For the best performance, use the "quietest" supply available (on an Arduino, this would be the 3.3V supply). The audio waveform will come out of the OUT pin. The output will have a DC bias of VCC/2 so when its perfectly quiet, the voltage will be a steady VCC/2 volts (it is DC coupled). If the audio equipment you're using requires AC coupled audio, place a 100uF capacitor between the output pin and the input of your device. If you're connecting to an audio amplifier that has differential inputs or includes decoupling capacitors, the 100uF cap is not required.
The output pin is not designed to drive speakers or anything but the smallest in-ear headphones - you'll need an audio amplifier if you want to connect the amp directly to speakers. If you're connecting to a microcontroller pin, you don't need an amplifier or decoupling capacitor - connect the OUT pin directly to the microcontroller ADC pin.
Package includes: 1PCS Microphone Amplifier Module MAX4466 w/ Adjustable Gain For Arduino

On 26-Feb-21 at 04:45:59 EST, seller added the following information:



Buy Now

Intermatic K4221c 120-volt Stem And Swivel Mount Photo Control , New picture
Intermatic K4221c 120-volt Stem And Swivel Mount Photo Control , New


Lutron Qsyc4-rcvr Shading sivoia Qs Wireless Receiver picture
Lutron Qsyc4-rcvr Shading sivoia Qs Wireless Receiver


Downstream Oxygen O2 Sensor For 2011 Hyundai Sonata L4-2.4l 2.0l Kia Optima picture
Downstream Oxygen O2 Sensor For 2011 Hyundai Sonata L4-2.4l 2.0l Kia Optima


Safety Light Curtain Bem0440-30nb Dustproof Good Sealing Npn-nc Output picture
Safety Light Curtain Bem0440-30nb Dustproof Good Sealing Npn-nc Output


Popular Forums